![]() ![]() On the Indy, this also erases the Ethernet MAC address of the system (sets it to ff:ff:ff:ff:ff:ff). Cosmo Compress (part number 030-8139-00x) - provides MJPEG compression and decompression, connects to the Indy Video board via an internal ribbon cable.Īs in all other systems using these all-in-one Dallas RTC modules, the module's battery eventually fails.Indy Video (part number 030-8138-00x) - provides uncompressed analog video I/O with composite and S-video ports.1/8" jacks for: line in, line out, headphones, microphone, speakers,Īpart from the built-in options above, the following two GIO video cards were available:.The Indy comes with quite a few built-in multimedia I/O ports: None of the graphics options on the Indy support hardware texturing. ![]() The PROM version must be "June 20, 1994" or later to support XZ graphics. size of the boards and their heat dissipation). No dual-head option is available for XZ graphics, most likely because of physical constraints (i.e. However, in an R5000 Indy, the CPU is faster than the geometry engine on the XZ graphics, so the XL boards are preferable in this case (unless you also need depth-buffering, in which case the XZ board takes the lead again). The advantage over the XL boards is that XZ does geometry calculations in hardware instead of on the main CPU. The Express (XZ) graphics come in only one form: a two-board set (part number 030-8234-00x + 030-8235-00x). A dual-head XL8 configuration is possible, but requires a special dual-head board (part number 030-0899-00x), since it's not possible to just plug in two XL cards. There are two different Newport (XL) graphics boards: XL8 (8-bit color, part number 030-8124-00x) and XL24 (24-bit color, part number 030-8131-00x). Both implement OpenGL 1.0 (plus SGI extensions). Indy has two different families of graphics options that attach to its GIO32bis bus: Newport (XL) and Express (XZ). ![]() Fill the slots nearest to the power supply first. Sticks must always be installed in groups of four equal sticks. The maximum configuration is 256MB (eight 32MB sticks) and the minimum is 32MB (eight 4MB sticks). The Indy motherboard has 8 sockets for industry-standard 72-pin FPM (fast page mode) SIMMs with parity. The PROM can be upgraded to a newer version only by using an external EPROM programmer, since it's stored in an older UV-erasable EPROM chip (M27C4002-12FI, a 256Kx16 device with 120ns access time). ![]() The R4400/200 processor needs PROM version "July 15, 1994" or later, the R4600/133 needs "Sept 28, 1994" or later, and the R5000 processors need "February 12, 1996" or later. Some processor options require a PROM upgrade to work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |